Testimonials
Screen Share
|
"FIREPLUG" 5/8" VARIABLE FLUTE STUB CARBIDE ROUGHING ENDMILL
Product Reviews
| (4 Ratings, 3 Reviews) |
Average Rating:
|
"The Little Bad Wolf"
Lars
(Erie, PA)
12/3/2019 6:11 AM
I use this tool often on 4140PH/4150PH, A2 and 1018. The product description is not overly hyped. This tool is the bully on the block, it has been given the nickname “The Little Bad Wolf” on the shop floor. This cutter will just keep eating more chip load and more radial engagement at full DOC. We look for excuses to use this tool at this point, it is that fun the watch even under flood coolant! This is one of those tools that removes material so aggressively the thought “yeah, I am going to double check and make sure that vice is REAL tight” will go through your head when you finally get the courage to run this at 100%. The Fire Plug should go in the “Roughing Hall of Fame” right next to the TAS rougher.
|
True work horse
Andrew Gehret
(Williamsport, PA)
3/3/2017 2:32 PM
This tool is one of the amazing work horses in my inventory. I rely on it heavily.
|
Did 200 pieces well done
Hisham Nasser
(Lower Hutt, )
8/25/2015 8:47 PM
well, I tried many cutters but this guy did 200 pieces of lazered cut parts about 18 inc countouring dia on mild steel 250G 20mm deep 1 cut. after 170 pieces the cutter start to wearout but managed to push it to 200 mark.
didnt chip but does get warn after many hard cuts..
use anti climb milling for hardend lazer layers.
|
|
|