
Testimonials
Screen Share
|
3/16" STUB CARBIDE BALL END MILL 4 FLUTE ALTIN COATED
Product Reviews
(1 Rating, 1 Review) |
Average Rating:
|
I started using this one months ago and I'm still on the same tool
James
(KY)
12/6/2014 11:56 PM
If you are doing 3D machining without too much DOC, you owe it to yourself to try this one out. The first ballmill I tried from a different manufacturer was a standard length and broke within 2 minutes of the cut. I switched to this stub length from Lakeshore Carbide over 6 months ago and ordered several thinking breakage was likely at some point. Today I am still on the same tool, and I've used it A LOT, many hours of cumulative machining time. I have no plans on switching out to a new one anytime soon since it is still cutting perfectly.
|
|
|